Skip to content
UA Discuss your project
  1. Home
  2. Resources
  3. HACCP log sample: columns to include and how camera cards complement a paper log

HACCP log sample: columns to include and how camera cards complement a paper log

9 min read · Updated 2026-11-03

Author: DuoVision team

For: technologists, heads of quality and HACCP, directors of food plants setting up or updating their logs

Summary

  • Law No. 771/97-VR requires documents and records that confirm the HACCP principles are applied, kept for at least three months after the minimum durability date or use-by date of the product.
  • Order No. 590 does not approve a single log form. It describes what a record must show: what was measured or seen, by whom, when, what was done about a deviation and who checked it. The columns follow from that.
  • Food plants usually keep logs for staff hygiene, temperature, cleaning and disinfection, and monitoring of critical control points. Each has a sample table below with illustrative data.
  • A camera with a card and a person's decision replaces none of these logs. It gives a frame as evidence for the rows about people's behavior and the state of zones, and shows that a deviation was noticed and reviewed.

For: technologists, heads of quality and HACCP, directors of food plants setting up or updating their logs

What the law and the order say about records

Article 21 of Law No. 771/97-VR, in part three, names the seventh HACCP principle: preparing documents and keeping records to confirm that the measures under principles one to six are applied effectively. Item 3 of part six requires the operator to keep documents and records on these principles for at least three months after the minimum durability date or the use-by date shown on the label.

Order No. 590 of the Ministry of Agrarian Policy of 01.10.2012, in item 3.26, divides documentation into basic (the HACCP plan and procedures) and operational (protocols and records). Operational documents include minutes of HACCP team meetings and protocols of monitoring of critical control points (CCPs), of corrective actions, of validation and of verification. Several more requirements shape what a log looks like:

  • monitoring protocols are filled in immediately after the measurement or observation (item 3.23.1), signed by the person who did the monitoring and checked by an authorized person (item 3.23.5);
  • corrections to records are made only by authorized persons (item 3.26.7);
  • records can be integrated into the existing document system and existing forms such as production logs can be used (item 3.26.4);
  • electronic protocols are allowed if they are complete, stored so that unauthorized changes are impossible, and available on request (item 3.26.5).

A separate case is in part four of article 21 of the law. Under a simplified approach, if monitoring procedures are visual, records can be kept only when a nonconformity is found, and they must describe the corrections and corrective actions. The law allows a simplified approach on condition of the same level of consumer health protection. Whether it suits you depends on the risk of your production and the decision of your HACCP team.

We did not find an approved mandatory form called "HACCP log" in the order. So any "sample", including ours, is an example of how to build a record that meets the requirements above.

Which logs a food plant keeps

Names and numbers of logs differ and are set by the HACCP plan and prerequisite programmes of each company. Four groups come up most often.

LogWhere the requirement comes fromWhat it records
Staff hygiene and healthOrder No. 590, item 2.10 (including 2.10.4 on the check before work); article 48 of the lawAdmission to the shift, check for signs of illness, exclusion from work, briefings
TemperatureItem 2.15 (storage and transport), item 3.23.4.1 (temperature as a monitoring parameter together with time)Instrument readings in cold rooms, in storage and during transport
Cleaning and disinfectionItem 2.9 (surface cleanliness)What was treated, when, with what, who did it and who checked
CCP monitoringItems 3.23 (principle 4) and 3.24 (corrective actions)Measurements at critical points against critical limits, deviations, corrective actions

A company may also keep logs for pest control (item 2.12), verification, staff training and instrument calibration. We do not detail them here.

Sample: staff hygiene log

Item 2.10.4 of the order requires checking staff appearance before work for signs of pustular conditions, taking into account reports of signs of infectious illness or contact with sick people, and not admitting to work anyone who could contaminate the product. Item 2.10.2 adds medical examinations and personal medical books. A log built from this looks like the following.

Date, shiftName, positionMedical book validCheck before workComplaints or contact with sick peopleAdmissionSignature of the checker
03.11, morningIvanenko I., bonerYesNo signsNoneAdmittedForeman, signature
03.11, morningPetrenko P., packerYesCut on palmNoneAdmitted after dressing with a waterproof plaster, glovesForeman, signature
03.11, morningSydorenko S., loaderYesNo signsCough, feverNot admittedForeman, signature

Illustrative data, only to show the format.

Rules of conduct (item 2.10.5: entry and exit, jewelry, food, hand washing, work clothing) have no separate row in this log, because compliance is visible in the workshop. That is where cameras help, as described below. Fields, signatures and what not to record are covered in the staff health log.

Sample: temperature log

Item 3.23.4.1 of the order requires combining temperature with time when it controls pathogens. For storage and cold rooms the log needs the reading, time, instrument and the response to a deviation. Limits come from the HACCP plan, and there are no universal limits.

Date and timeRoom or pointInstrument (no.)Reading, °CLimit per plan, °CDeviationActionSignature, checked by
03.11, 06:00Chill room 1T-14+2.1up to +4 (illustrative)NoNone neededOperator, foreman
03.11, 14:00Chill room 1T-14+5.3up to +4 (illustrative)YesDoor checked, product moved to room 2, mechanic called, batches recordedOperator, technologist

Illustrative data and an illustrative limit, only to show the format.

Item 3.24.3 of the order says what a corrective action must do: restore control, find and remove the cause, identify potentially unsafe product made while control was lost, and decide what to do with it. That is why the sample has an "Action" column and a note on batches.

Sample: cleaning and disinfection log

Item 2.9 requires documented and fully implemented procedures, frequency set on a risk assessment, evidence that procedures are carried out at the right frequency and are effective (visual inspection, laboratory monitoring), and that the check is done by an employee not involved in the cleaning itself (item 2.9.5).

Date, timeArea, equipmentType of treatmentAgent, concentration per procedurePerformed byCheck (visual, swab)ResultSignature of the checker
03.11, 21:30Boning table 3Washing, disinfectionPer procedure no. (illustrative)Cleaning crewVisualAcceptedTechnologist, signature
03.11, 22:10Floor by the drainWashing, disinfectionPer procedure no. (illustrative)Cleaning crewVisualFat residue, washed againTechnologist, signature

Illustrative data, only to show the format. Laboratory swab results can be kept in a separate protocol referenced from this log.

Sample: CCP monitoring log

This is the log the order places the most requirements on. Item 3.23.4 says what a monitoring procedure must contain: the parameter, the method, the frequency and who is responsible. The log repeats that structure and adds the critical limit from the plan and the corrective action.

Date, timeCCP no. and stepParameterCritical limit per planMethod, instrumentResultDeviationCorrective actionPerformer's signatureChecked by
03.11, 09:15CCP 1, heat treatmentCore temperature of productPer plan (illustratively X °C)Probe no. (illustrative)Meets limitNoNone neededOperatorTechnologist
03.11, 11:40CCP 1, heat treatmentCore temperature of productPer plan (illustratively X °C)Probe no. (illustrative)Below limitYesBatch returned for treatment, cause found, time and performer recordedOperatorTechnologist

Illustrative data. Critical limits come from your HACCP plan.

Item 3.24.6 requires documenting the steps of corrective actions, for example date, time, action, performer and next check. Item 3.24.7 says that when corrective actions become frequent, their effectiveness is checked and procedures are improved (for example equipment calibration, checks that staff do their duties), or the process, product or plan is adjusted. So it helps to look regularly at how often "Yes" appears in the Deviation column.

Columns every log needs

From items 3.23, 3.24 and 3.26 and from our practice comes a short list that fits each log above. Items 4 and 8 are our advice, the order does not literally require them.

  1. Date and time of the entry, made right after the measurement or check.
  2. What was checked: area, equipment, person, batch.
  3. Result: a value or a conclusion.
  4. The limit it was compared with and where it is written (plan, procedure).
  5. Deviation: yes or no.
  6. Action on a deviation: what was done, with whom, when.
  7. Signature of the person who did it and of the person who checked it.
  8. For corrections: who corrected the entry, when and why. Under item 3.26.7 only an authorized person corrects.

For an electronic log, item 3.26.5 requires that records be protected from unauthorized changes. How the performer and the checker are confirmed is something the company describes in its own procedure.

How cameras with a card and a human decision complement a paper log

A camera does not measure temperature, confirm disinfectant concentration or take swabs. Instruments, the laboratory and a signature remain for those rows. Where an entry concerns people's behavior and the state of zones, a video card gives what a paper row lacks: a frame, a time and a camera.

At the meat processing plant where we ran the system, we checked on real events the cap or hairnet, mask, beard cover, gloves and boxes directly on the floor. How this maps onto the logs:

LogWhat a video card adds
Staff hygieneUnder a row saying "admitted" you can place frames showing that people in the zone were wearing caps, masks and gloves (we have tested those rules). Some of the rules of conduct in item 2.10.5 are visible in the zone, not only in a foreman's signature at the start of the shift
Cleaning and disinfectionA box of product directly on the floor shows up in a frame, not in the log. The treatment itself and its result are not confirmed by a camera
TemperatureNothing for the temperature itself. An open cold room door or ramp gate can be caught as a separate rule if it is set up for the site
CCP monitoringOnly where the critical limit is tied to behavior that video can show. Otherwise the CCP stays with instruments

In practice it works like this. The system prepares a card (frame, rule, camera, time), the responsible person at the company decides "violation" or "not a violation", and confirmed violations can go into the log together with the correction and the corrective action, which the company's people write down. That matches what the order asks of records: what was found, when, what was done, who checked. For a simplified approach with visual monitoring, part four of article 21 of the law explicitly allows records only of nonconformities with a description of corrections.

For an electronic log of cards to hold up as a record, meet the conditions of item 3.26.5: the record is complete, protected from unauthorized changes, kept for the period in item 3 of part six of article 21 and available on request. Frames with people are personal data, so restrict access by role. We covered this in the article video analytics and personal data.

For more on what IFS, BRCGS and FSSC 22000 auditors ask about this, read HACCP and video monitoring. For individual rules see caps and gloves.

Where to start

  1. List the logs you already have and match them to the HACCP plan and prerequisite programmes.
  2. For each, check the column list above: is there a limit, a deviation, an action and two signatures.
  3. Decide which rows concern people's behavior and the state of zones, that is, what a frame can confirm.
  4. Run video monitoring for those rules in shadow mode and see on your own events how many cards there are and how many your people confirmed.
  5. Move only confirmed rules into daily work and the log.

To check that the logs are kept properly, use the internal HACCP audit checklist.

We tune the system to each site and start in shadow mode. Only the rules named above are proven; we check the rest in your workshop.

Where to apply this

Sources

  1. Law of Ukraine "On basic principles and requirements for the safety and quality of food products" of 23.12.1997 No. 771/97-VR (articles 21 and 48; edition of 22.07.2026)
  2. Order of the Ministry of Agrarian Policy of 01.10.2012 No. 590 "On approval of requirements for developing, implementing and applying permanent procedures based on the principles of the food safety management system (HACCP)" (items 2.9, 2.10, 2.12, 2.15, 3.23-3.26)

Let’s discuss your site

Request a consultation or a project estimate. We will tell you what your cameras can monitor, where it is best to process the video and how much it will cost.